CA Directory install as non-root user

Document ID:  TEC1966154
Last Modified Date:  08/07/2017
{{active ? 'Hide' : 'Show'}} Technical Document Details

Products

  • CA Directory

Releases

  • CA Directory:Release:12.0
  • CA Directory:Release:12.5
  • CA Directory:Release:12.6

Components

  • CA Directory:ETRDIR
Introduction:

NOTE: This is only applicable to version 12.0.15 and higher as support for installing as non-root user was only added starting CA Directory r12.0 SP15. Any previous version are still required to be installed as 'root' user.

Question:

Even though user 'xyz' is created and you are currently logged in as that user and also confirmed that this user has a description of 'DXserver Administrator' defined properly, installation of CA Directory on Linux still fails with:

User xyz has to be created with description "DXserver Administrator" in case of non-root install/upgrade/uninstall. Exiting the operation.

Answer:

Most probably this is a centralized user. To confirm, run the following command:

grep -c "DXserver Administrator" /etc/passwd

If the user is present locally on the server, it should return '1'.

If the user is centralized, it should return '0'.

If you get '0' as an output, possibilities are you are installing version 12.0 SP15 or higher where installing as non-root user is supported but that non-root user has to be local. Centralized user is not support in 12.0 version of CA Directory while the support for this enhancement was added in 12.6 release. So the solution would be to use CA Directory 12.6.x version if you cannot have this "DXserver Administrator" defined in /etc/hosts file.

Please help us improve!

Will this information enable you to resolve your issue?

Please tell us what we can do better.

{{feedbackText.length ? feedbackText.length : '0'}}/255

{{status}}

Not what you were looking for?

Search Again >

Product Information

Support by Product >

Communities

Join a Community >