WAAE/CA7 Cross-Platform Command Job Parameters

Document ID:  TEC1922948
Last Modified Date:  08/03/2017
{{active ? 'Hide' : 'Show'}} Technical Document Details

Products

  • CA Workload Automation AE

Releases

  • CA Workload Automation AE:Release:11.3
  • CA Workload Automation AE:Release:11.3.5
  • CA Workload Automation AE:Release:11.3.6

Components

  • CA Workload Automation AE (AutoSys):ATSYS
Introduction:

This information applies to environments where jobs are submitted directly from WAAE to CA7 without going through the AutoSys/Connect application on the mainframe.

Question:

When submitting a job directly from WAAE to CA7 via the Cross Platform Interface, what parameters can be specified in the "command" attribute in WAAE job?

Answer:

For a WAAE command job that is defined to execute a job in CA7 directly, the following parameters can be specified in the WAAE job's "command" attribute. Each parameter must be separated by a comma.

 

JOBNAME - (REQUIRED) Specifies the CA7 job name to be executed. This is the only required parameter and must be the first parameter specified.

MONITOR=monitorname - (OPTIONAL) As defined in the SVCNO parm in the CA-7 Init file. This identifies the CA-7 instance that you will pointing to and is usually only required if you are executing more then a single CA-7 instance.

XPSSCHD=xxxxxxx - (OPTIONAL) Depending on the value of the XPSSCHD parameter in your CA-7 Init File you can state which method (Demand or Run) should be used when bringing a job into CA-7

SCHID=xxx - (OPTIONAL) This parameter can be used to force CA-7 to bring in a job with a specific SCHID value. If not, the default schid of 000 will be used. 

 

The syntax for command attribute for the WAAE job would be...

command: JOBNAME,MONITOR=monitorname,XPSSCHD=xxxxxxx,SCHID=xxx

NOTE: The optional parameters can be specified in any order after JOBNAME.

 

 

 

Additional Information:

This information also applies to WAAE jobs that submitting directly to CA Jobtrac and CA Scheduler.

Please help us improve!

Will this information enable you to resolve your issue?

Please tell us what we can do better.

{{feedbackText.length ? feedbackText.length : '0'}}/255

{{status}}

Not what you were looking for?

Search Again >

Product Information

Support by Product >

Communities

Join a Community >