New Data Repository installation shows error during validation of the connection properties for the database.

Document ID:  TEC1623703
Last Modified Date:  07/11/2017
{{active ? 'Hide' : 'Show'}} Technical Document Details

Products

  • CA Performance Management

Releases

  • CA Performance Management:Release:3.1
  • CA Performance Management:Release:3.0
  • CA Performance Management:Release:2.8

Components

  • IM DATA STORAGE:IMSTOR
  • IM REPORTING / ADMIN / CONFIGURATION:IMADMN
Problem:

When running the Data Repository validation script an error message is returned resulting in an inability for the installation to proceed.

The error states the following:

 

Validating connection to database host: DR_DB_Host.CA.com

Verifying database connection properties................................[FAIL]

Environment:
3.1 (applicable to all supported releases)
Cause:

At that point of its run, the validation script is performing a check for a DB connection. This check is only performed when the validation script believes there is already a DR DB installed. Why would that be in what should be a new installation run for the first time?

There as a past attempt to install the software that was not completed successfully. The failed installation was partially removed with the /opt/vertica directory remaining. This caused the validation script to believe it is an update not a new install.

Resolution:

Remove the failed install fully, including deleting the /opt/vertica directory.

Once done the validate script should no longer throw an error message.

Additional Information:

See Uninstall section of Installation section in CAPM Wiki docs for Vertica uninstall instructions.

Please help us improve!

Will this information enable you to resolve your issue?

Please tell us what we can do better.

{{feedbackText.length ? feedbackText.length : '0'}}/255

{{status}}

Not what you were looking for?

Search Again >

Product Information

Support by Product >

Communities

Join a Community >