How to deactivate alarm_enrichment probe

Document ID:  TEC1373982
Last Modified Date:  07/05/2017
{{active ? 'Hide' : 'Show'}} Technical Document Details

Products

  • CA Unified Infrastructure Management

Releases

  • CA Unified Infrastructure Management:Release:8.5
  • CA Unified Infrastructure Management:Release:8.4

Components

  • UIM - ALARM_ENRICHMENT:UIMALM
Introduction:

If you are not using enrichment scripts in alarm_enrichment and would like to remove the alarm_enrichment probe below are the steps.

Instructions:

1) Deactivate both probes 'nas' and 'alarm_enrichment' 

2) Open Raw Configure for nas probe

3) Under setup folder, find the 'subject' key. change the value from 'alarm2' to 'alarm' - then Apply/Save 

4) In the controller.cfg remove the section <alarm_enrichment></alarm_enrichment> and under the <nas></nas> section, remove ‘start_after = alarm_enrichment’ 

5) Open the hub probe GUI 

6) Go to queues 

7) Remove the alarm_enrichment queue 

8) Change nas queue from alarm2 to alarm (via right click & edit) save / apply and restart hub (ensure robot is restarted via the service [nimbus daemon on Unix or 

Windows service controller on Windows]) 

9) Activate the nas probe  

Please help us improve!

Will this information enable you to resolve your issue?

Please tell us what we can do better.

{{feedbackText.length ? feedbackText.length : '0'}}/255

{{status}}

Not what you were looking for?

Search Again >

Product Information

Support by Product >

Communities

Join a Community >